A pipe usually fails inside a wall cavity, which means the visible damage is only a fraction of what's actually happening behind the drywall.
We open the wall cavity carefully, only as far as moisture readings say is necessary, rather than tearing out an entire wall.
We'll walk you through shutoff steps over the phone if you call before we arrive.
Pinpointing the break location prevents unnecessary demolition in the wrong section of wall.
Drywall and insulation come out only where moisture readings confirm saturation, not the entire wall.
Handoff to a licensed plumber is built into our burst pipe process, not left for you to arrange separately.
Here's the full scope of a burst pipe response in Union.
We locate and confirm the shutoff valve is closed the moment the crew arrives.
We locate the failure point before opening any drywall, avoiding guesswork demolition.
Water trapped inside the wall cavity gets extracted using specialized tools designed for tight spaces.
Saturated insulation is removed and replaced, while drywall is cut only at the confirmed wet line.
We dry wall framing directly, not just the room's ambient air.
Plumbing repair coordination is included so you're not managing two separate contractors.
Tell our Union, SC dispatcher if the water source is still running so we can advise on shutoff immediately.
Equipment for wall cavity work is brought along by default for burst pipe calls.
You'll see the scope and cost once the failure point is confirmed.
The job isn't done until both drying and repair coordination are confirmed.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
Sudden water flow or a fast-spreading stain typically points to a burst rather than a slow leak.
No, we remove drywall only at the confirmed wet line based on moisture readings.
We handle the water damage mitigation and coordinate directly with a licensed plumber for the pipe repair itself.
Avoid the area near standing water and electrical outlets until our technician confirms it's safe.
Wall cavity drying typically takes 3-5 days depending on how much insulation and framing was affected.
If your address is in or near Union, a crew can typically respond the same day.
One call gets a Union, SC crew routed to Union with the right equipment.
Call +1-844-833-1325